GE AGP07 Manual De Instrucciones página 10

Installation Instructions
[] INSTALL THE SUPPORT BRACKET
[] Depending on the slant and depth of your
window sill, choose either the short or long
leveling bolt and thread it through the
appropriate hole in the bottom of the
support bracket.
Choose•
)rlate
Sill
Stool
[] Place the support bracket on the sill,
against the back edge of the stool, with
its 3 holes positioned on the 1" line. Loosely
attach the support bracket with two Type A
screws.
/_ Loosely attach the
] _ support bracket with
two Type A screws
[] Adjust the leveling bolt in the support
bracket so that it is installed with a slight tilt
to the outside. Use a level; about 1/3 bubble
will be the correct slant to the outside.
Tighten the Type A screws.
L
lqghten Type
A screws
Stool
INSIDE
Support
bracket
t ......... About I/3
,_ ...... bubble
Adj ust
leveling bolt
I I OUTSIDE
[] INSTALL THE AIR CONDITIONER
IN THE WINDOW
_tl CAUTION: Do not r elease grip onthe
air conditioner until this step is complete with the
unit secured in the support bracket and with the
window closed in the top channel.
[] Using the hand holds, center the air
conditioner in the window with the bottom
mounting rail between the window stool
and the support bracket trap rail. Close the
window into the top channel.
Window _ ] Hand hold
Top channel._ JJr__i
Bottom
mounting rail _Support bracket
Stool _ _trap rail
INSIDE _ I OUTSIDE
[] Extend the accordion panels to fill the
window opening and use 4 Type B screws to
secure the top and bottom corners.
[]
[]
[]
Install Type B screws
INSTALL THE WINDOW LOCKING
BRACKET AND THE FOAM TOP
WINDOW GASKET
Attach the window
locking bracket with a
Type B screw.
Cut the foam top
window gasket to the
window width.
Stuff the foam
between the glass and
the window to prevent
air and insects from
getting into the room.
I
10