Publicidad
Idiomas disponibles
Idiomas disponibles
Lights next to the touch pads on the air conditioner
control panel indicate the selected settings.
gecom
COOLMode
Use the COOL mode with HIGH(F3),MED (F2)or
LOW(FI) tim for cooling. Use the Increase• /
Decrease• pads to set the desired
temperature
between
60°F and
86°F in l °F increments,
An electronic
them_ostat
is used
to maintain
the
room
temperatm'e.
The
compressor
will cyde
on and
off to kee I) the
room
at the set level of comfiwt.
Set
the them/ostat
at a lower
number
and
the indoor
air
will become
cooler:
Set the them_ostat
at a higher
number
and
the
indoor
air will become
wam/e_:
NOTE" ff the air conditioner is off and is then tumed on
while set to COOL, it will take approximately3 minutes
for the compressorto start and cooling to begin.
CoolingDescriptions
ForNormalCooling--Select the COOL mode and
HIGH(1:3) or MED(F2)fim with a nfiddle
set
temperature.
ForMaximum
Cooling--Select
the COOL mode
and HIGH(F3)fire
with
a lower
set temperatm'e.
ForQuieter& Nighttime
Cooling--Select
the
COOL
mode
and
LOW (FI)fire
with
a middle
set
temperatm'e.
NOTE:If you switch from a COOL setting to OFFor to
a fan setting, wait at least 3 minutesbefore switching
back to a COOL setting.
FAN Mode
Use the FANat HIGH(F3), M ED (F2)or LOW(FI) to
provide
air circulation
and
filtering
without
cooling.
Since
tim only
settings
do not
provide
cooling,
a temperatm'e
setting
will not
be displayed.
Air Direction--Side-to-Side
The side-to-side air direction is ac!iusted 1)ymoving
the
lever
to the
left or right.
Air Direction--Up
and Down
Fingertip
pressm'e
on the horizontal
lou\'e_
a_!iusts
the
air direction
up or down.
NOTE" For best cooling efficiency,angle the louvers up.
Publicidad
