MSW Motor Technics MSW-POWER 700 Manual De Instrucciones página 14

3.2. Preparing for use
APPLIANCE LOCATION
The temperature of environment must not be higher than 40°C and the relative humidity should be less
than 85%. Ensure good ventilation in the room in which the device is being used. There should be at least
10 cm distance between each side of the device and the wall or other objects. The device should always be
used when positioned on an even, stable, clean, fireproof and dry surface, and be out of the reach of
children and persons with limited mental and sensory functions. Position the device such that you always
have access to the power plug. The power cord connected to the appliance must be properly grounded
and correspond to the technical details on the product label.
3.3. Device use
How do you know whether electronic devices will work with a power station?
Firstly, determine the amount of energy required by the electronic device. This may need to be
investigated yourself, checking the user manual of the electronic device should suffice. Secondly, check the
performance of the individual output ports. For example, the AC port of the A700 is monitored by an
inverter that allows 700 W of continuous power. This means that if the device draws more than 700 W for
an extended period of time, the portable power station will shut down.
NOTE:
1. When the battery voltage drops below 2.5 V, both AC and DC cease to operate, the power station
should be switched off to protect the batteries from damage due to loss of power.
2. When the battery charge level is 3% or lower, the battery charge level symbol changes from green to
red.
3. If possible, fully charge the power station before prolonged downtime. (For long-term use, fully charge
the station at least every 6 months).
3.3.1. How to charge the power station
3.3.1.1. Wall charger
Plug the charging cable into a wall socket, then plug the other end into the input port 7909 (14) of the
portable power station, the charging indicator will turn green (3), (4). Recharge only with the charger
specified by the manufacturer.
3.3.1.2. Charging with solar panel
Place the solar panel in a location where it will be exposed to direct sunlight. Connect the solar charger
using the solar charging cable, then connect the cable with connector 7909 to the input port (14). The
charging status (3), (4) can be checked on the LCD display. Charging will end when the battery is full of
energy.
EN