Publicidad
Idiomas disponibles
Idiomas disponibles
7.2 Heating a horizontal workpiece
•
This is only possible if the bore of the workpiece is large enough to fit over the pole.
•
Place the workpiece as centrally as possible around the pole on the horizontal supports.
•
The workpiece may not be wider than the horizontal supports.
•
Always choose the largest induction yoke.
•
Make sure that the bare-metal sides are sufficiently coated with acid-free grease to ensure
optimal contact and avoid vibration.
•
Always make sure that the workpiece does not come into contact with the plastic casing of the
heater. When the heating is finished, follow the instructions in reverse order. Use heat-resistant
gloves to move the heated workpiece.
7.3 Maximum weights
Table for maximum permitted weights on the horizontal support and the (swivel) yokes:
On
Type
supports
VHIN-G2-10
-
VHIN-G2-35
50 kg
VHIS-G2-75
100 kg
VHIS-G2-100
150 kg
VHIS-G2-150
200 kg
VHIS-G2-200
400 kg
VHIS-G2-400
600 kg
VHIN-G2-600
800 kg
VHIN-G2-800
1600 kg
•
Keep to these maximum weights and avoid tilting the heater or damaging the supports,
(swivel) yokes or hinge.
NOTE!
•
Always handle induction yokes with care. They are damaged easily when dropped, knocked
against something, etc. Store them immediately after use.
7
10
14
20
1 kg
2 kg
3 kg
5 kg
1 kg
2 kg
3 kg
5 kg
-
2 kg
3 kg
5 kg
-
-
-
10 kg
-
-
-
10 kg
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
Size of (swivel)yokes (mm)
30
40
50
-
20 kg
-
10 kg
15 kg
-
10 kg
15 kg
20 kg
15 kg
25 kg
40 kg
45 kg
15 kg
25 kg
40 kg
45 kg
-
-
-
60 kg
-
-
-
60 kg
-
-
-
-
-
-
60
70
80
90
-
-
-
-
-
-
-
-
-
-
-
-
50 kg
-
-
50 kg
-
-
-
80 kg
-
-
-
80 kg
-
-
-
-
-
-
-
-
17
EN
DE
ES
FR
NL
Publicidad
