Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical Connections
Caution:
e This product is designed to operate with a 12 V DC, negative ground battery system.
e To prevent damage to the unit, be sure to follow the connection diagram below.
e Remove approximately 4" (5 mm) of protective covering from the ends of the leads before connecting.
e Do not insert the power connector into the unit until the wiring is completed.
e Be sure to insulate any exposed wires from a possible short-circuit from the car chassis. Bundle all cables
and keep cable terminals free from touching any metal parts.
e Remember, if your car has a drive computer or a navigation computer, the data of its memory may be
erased when the battery terminals are disconnected.
O Wiring Diagram
Antenna
External amplifier control lead
©
C$
A
(Max. 500 mA)
(Blue/white stripe)
This lead is for connection to the power amplifier.
Note:
e This lead is used for power control when an external power
amplifier is connected. The power supply of a power amplifier
will be activated when turning on the power of this unit.
Not used.
—_—_
_
A
-_AK<———
GG
7
(Brown/white stripe)
Note:
e Insulate this lead with vinyl tape.
Motor antenna relay control lead
=
CI
=
(To motor antena) (Max. 500 mA)
(Dark blue)
This lead is not intended for use with switch actuated power antenna.
Note:
e The power antenna extends automatically when the AM/FM
radio mode is selected.
Registor (1 KQ)
ACC power lead <_—___——___-
To ACC power, + 12 V DC.
(Red)
Fuse (15 A)
Battery lead —————————
To the battery, continuous +12 V DC.
(Yellow)
Ground ad
___Û_———
anna
aa
— .—————
To a clean, bare metallic part of the car chassis.
(Black)
a8
CQ-DF602U
Publicidad
