JENN-AIR JBI800 Guia Del Usuario página 9

Removing pitcher from base
1. Make sure the blender controls are set to "OFF"
and the power cord is unplu_ed.
2. Tm'n the pitcher counterclockwise and lilt the
pitcher up and off the base.
3. I)o not unscrew the base ring fl'om the pitcher jar
until you are ready to remove the blade assembly.
Loosening it will cause leaking.
NOTE: Be sure to operate ,your blender on a clean,
dry, sturdy suvtace.
Operating Your Blender
1. Make sure the touch controls are SET TO "O FF" and l /
the power cord is unplugged. /
2. Place the assembled PITCHER ON TOP OF \
F, L ENI)ER BASE and tul'n clockwise to lock the
pitcher in place.
3. LOAD BLENI)ER with tood to be blended and place
the lid securely on flae pitcher jar.
4. TOU(H THE "ON" PAl) on the control panel. The
"ON" pad should illuminate and the WARNING light will flash to indicate that
the blender is ready to operate.
5. TOU(H ONE OF THE FIVE SPEED PAI)S. Reter to the "Speed (ontrol
Guide" in this manual tor suggested settings. Reter to the "Pulse Mode" and
"Ice Crushing Mode" sections in this manual tot use of those controls.