Melchioni Family VEGA Manual De Instrucciones página 21

Product specification and main parameters
Nominal Voltage : 220 - 240V
Nominal Frequency: 50 - 60Hz
Nominal Power consumption: 150W
Nominal time: ≤ 20min
Troubleshooting
Phenomenon
The appliance stops
suddenly
The juice amount is
small or juice flows
out of the main
body
There is abnormal
noise
The container and
accessories are
dyed after use
CAUSE
A. The power plug is not properly
inserted
B. The quantity of fruit/vegetables put
into the juicer is too large
C. Hard fruit/vegetables are not cut
A. Dry materials stored in refrigerator
are used for squeezing
B. The rubber pad at the bottom of
the squeezing cup is not installed
property
A. Accessories are notproperty
installed
B. The appliance is put on an
uneven-surface
C. Parts cause extrusion sound
during squeezing
A. Dreg attaches to thecontainer.
B. The container and accessories
are likely to be dyed when materials
with pigment (such as carrots,
spinach, etc.) are used for squeezing.
METHOD
A. Insert the plug into the socket
B. Press "reverse" for 2-3s to make
fruit/vegetables return upwards; then
press "forward"(repeat the process about
3 times). If the machine still does not run,
clean the machine and start juicing again.
C. Hard fruit/vegetables (such as carrots)
should be squeezed after being cut into
strips.
A. The juice amount will increase if fruit/
vegetables are squeezed after being
immersed in clear water for sufficient water
absorption
B. Reinstall the squeezing rubber pad by
refer-ring to the installation method
A. Stop the appliance and check whether
the accessories are property installed.
B. Put the juicer on an even surface.
C. Certain friction noise can be heard when
carrots or apples are used for squeezing. It
has no impact on the process.
A. Clean the juicer soon after use.
B.Wipe the appliance with some edible oil
and clean it with some detergent.
21