Connecting The Speakers To The Subwoofer; Secure All The Cables In The Clip; Connecting The Subwoofer To The Mains - Loewe 66213D/T10 Instrucciones De Manejo

Connection

Connecting the speakers to the subwoofer

Satellite speakers
Thread the speaker cable through the hole in the enclosed speaker cover (A).
One of the two wires of the speaker cable ( C ) is marked black. Connect these
black marked wires with the black terminal on the subwoofer  ( wiring ac-
cording to the picture on the right) and the black terminal (B) on the speaker.
Connect the unmarked wires with the red terminals. Then press the cover (A)
back onto the satellite speaker.
Satellite
speakers
Standing speaker
Place the standing loudspeaker carefully on the cushioned rest. Turn the two
screw terminals (B) in counterclockwise direction until the openings of the
terminals are visible. Connect the black marked wire of the speaker cable to the
black terminal on the subwoofer  (see connencting diagram in illustration on
the right) and the black terminal (B) of the speaker respectively. Connect the
unmarked wires with the red terminals.
Standing
speaker
Position the speakers as described on pages 16 to 17 or mount the satellite
speakers on the wall with the wall holder or on the optional stand as described
in the respective installation instructions.

Secure all the cables in the clip

Open the cable clip  at the bottom of the subwoofer, lay all the cables in it
and close the clip again. This fixes the cables.
- 0
B
C
A
B
C

Connecting the subwoofer to the mains

Plug the mains plug of the subwoofer into a 0 V AC socket.
Front
left
Subwoofer
Power OUT
R
Surr.
L
R
Front C
L
System connector
Surround
left
Front
right
ON
OFF
Bass Intensity
Min. Max.
Phase
0 180
Line IN
Crossover Frequency
Right Subw. Left
Surr.
Front 50 250.
Right Center Left
230V~50/60Hz
Surround
right