Dehumidification - Siemens S1 RKM 10012 Instrucciones De Uso

Dehumidification

7
23:00
When set to, the appliance removes humidity from
the atmosphere. As a result, there is no
temperature regulation.
Turn drainage stopcock 90° in an anti-clockwise
direction.
Remove stopcock plug and insert drainage pipe.
stored in the main filter compartment.
Place a bowl at the drainage pipe outlet to collect
the condensed water in.
Put the air extraction duct in storage position.
Select the "Dehumidification"
mode button. Fig. 7.
The dehumidification function only works in
manual mode. The automatic "turbo" and "silent"
modes are not available for this function.
Manual mode is activated by pressing the
"speed" button once. The symbol
indicate the selection. You have two seconds to
select ventilator speed using buttons
>
and (up). The LCD screen indicates the
ventilator speed selected.
The amount of humidity removed from the
atmosphere can reach as much as max. 30 litres
of water/ 24 hours depending on room
atmosphere conditions and the ventilator speed
selected.
Warning!
Do not forget to put the plug back in place on
the drainage stopcock and to turn the stopcock
90° in a clockwise direction before setting the
appliance to the temperature control setting.
The appliance will shed water should you fail to
do so.
If the "Dehumidification" indicator light flashes,
atmospheric temperature is lower than 18°C.
This temperature is the lowermost limit for
operation of the dehumidification function and
the appliance turns itself off.
function with the
flashes to
<
(down)
35