Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY - BASE
It is HIGHLY recommended to use two people for the installation of this product. To
assemble, please perform the following steps:
1
Carefully lift both Base Pieces from the
shipping carton, keeping the unit's top-
side down. Remove the plastic wrapping
from the bottom to access the bases.
2
Insert the Connecting Rods into one of
the Base Pieces and then slide the other
Base Piece onto the Connecting Rods as
shown.
3
Secure the Base Pieces to each other
using the eight hex bolts (four hex bolts
for each Connecting Rod) making sure to
hand tighten each and then tighten 1/4
turn more, as over-tightening could cause
damage to the frame or Connecting Rod.
4
Insert the legs into the threaded holes at
each corner of the base by inserting the
leg and rotating clockwise until tight.
See the diagram on the following page when
assembling one Base.
See the diagram on page 8 when connecting
two Twin XL bases to form a King.
6
Publicidad
