Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
Care before installation
Before installing the appliance and connecting it to the power grid, wash the walls and all internal
accessories with lukewarm water and neutral soap so as to remove the typical smell of a brand
new product, then dry thoroughly, and make sure the drain hoses are properly connected (see the
"Maintenance and Care" section).
Never use detergents or abrasive cleaners, they will damage the inside coating.
Before plugging in the appliance, place it upright on a firm and dry floor for at least 30 minutes.
The appliance will switch on and start cooling 1 hour later, if this does not occur, make sure it is
properly plugged in.
Location
Warning!
Never expose the appliance to
Do not tilt the appliance at more than 45° when you move it to position it.
Install the appliance in a dry and well ventilated place.
The appliance should be located far from heat sources like radiators, boilers, sunlight, etc.
Do not use the appliance outdoors if it will be exposed to the sun and rain.
Do not place the appliance in a damp location or expose it to frost.
Your appliance is designed to function optimally at a given ambient temperature. In this case, it
is said to be designed for a particular "climate class". The climate class is clearly shown on the
ID plate (see the "Contact" chapter). The freezer may not maintain satisfactory inside
temperatures if it operates outside of the temperature limits set for the climate class it is
designed for. Ensure that the chosen location is compliant with these temperature limits:
Class
Ambient temperature
This refrigeration appliance is designed for use at ambient temperatures between
SN
10°C and 32°C
SN-ST
This refrigeration appliance is designed for use at ambient temperatures between
10°C and 38°C
This refrigeration appliance is designed for use at ambient temperatures between
SN-T
10°C and 43°C
N
This refrigeration appliance is designed for use at ambient temperatures between
16°C and 32°C
This refrigeration appliance is designed for use at ambient temperatures between
ST
16°C and 38°C
T
This refrigeration appliance is designed for use at ambient temperatures between
16°C and 43°C
Based on the above, avoid placing your appliance on balconies, verandas, terraces, in garages,
etc. Excessive heat in summer and cold in winter will prevent it from operating properly and
therefore properly conserving wine.
The appliance must be made suitably level by adjusting one or more of the adjustable feed
under the cabinet (see the "Levelling the appliance" section).
a
.
naked flame
Publicidad
