Maintenance; Changing The Battery; Cleaning The Lens; Cleaning The Housing - Egatronic 51261 Manual De Instrucciones

CHANGING THE BATTERY

To install or change the 9V battery, open the battery compartment the battery as shown in Figure 2.

CLEANING THE LENS

Blow off loose particles using clean compressed air.
Carefully wipe the surface with a moist cotton swab.
The swab may be moistened with water.

CLEANING THE HOUSING

Use soap and water on a damp sponge or soft cloth.
Caution
Symptom
OL (on display)
-OL (on display)
Blank Display
Laser does not work
The Thermometer conforms to the following standards:
- EN61326-1 EMC
- EN60825-1 Safety
Certification testing was conducted using a frequency range of 80 to 100MHz with instrument in
three orientations.
34
To avoid damaging the Thermometer, do NOT submerge it in water.

TROUBLESHOOTING

Table 4. Troubleshooting
Problem
Target temperature is over range
Target temperature is under range
Low Battery
Possible dead battery
1. Low or dead battery
2. Ambient temperature above
40ºC (104ºF)

CE CERTIFICATION

MAINTENANCE

2. Use in area with lower ambient
Action
Select target with specifications
Select target with specifications
Replace Battery
Check and / or replace battery
1. Replace battery
temperature.