OK. ODL 40450-B SAT Manual De Instrucciones página 39

RE-INSTALLATION OF THE TELEVISION
6 Switch the television on.
1. Press MENU and select Language under FEATURE. Select the desired menu language and
confirm by clicking OK.
2. Select CHANNEL and then press .
3. Select the relevant country under COUNTRY.
4. Under TV CONNECTION select the air (DVB-T), cable (DVB-C) or satellite (DVB-S2).
5. Select AUTO SEARCH on the CHANNEL menu.
> ALL
> DTV
> ATV
The search for channels may last for several minutes. Follow the directions on the screen.
(DVB-T) ANTENNA OR (DVB-C) CABLE RECEPTION
If both DVB-T and DVB-C reception is available in your country and if your television is equipped for
DVB-T and DVB-C reception in your country, select one of the two modes when you set the channels.
7 If you want to change the DVB setting in order to start setting new channels, then proceed as
follows:
1. Select DTV in INPUT.
2. Press MENU, select CHANNEL and then press .
3. Select the desired DVB setting under TV CONNECTION.
4. Press MENU repeatedly, if necessary, to exit from the menu.
Note
If you can use a DVB-T antenna input and a DVB-C input, you can set up your television for both
DVB- T and DVB-C broadcasting. Install both systems one after the other with the required settings.
SATELLITE RECEPTION
8 This television has a built-in DVB- S2 satellite receiver. Connect your satellite dish cable directly
to the television. Use a coaxial cable that is suitable for connecting to a satellite dish. Before the
installation ensure that the satellite dish is properly aligned.
1. Select DTV in INPUT.
2. Press MENU, select CHANNEL and then press .
3. Select satellite under TV CONNECTION and press OK.
4. Select Satellite system and press OK.
5. The television will display the current installation setting. If the current setting is in accordance
with the desired satellite installation, you can start scanning for satellites. Press the blue button
to start the scanning.
6. The television will search for available satellites within the range of your satellite dish. This may
take several minutes. If a satellite is found, its name and its reception strength will be displayed
on the screen. If there is a channel package available for one of the satellites that are found, you
can select the desired package.
7. Follow the directions on the screen to install the channels of the satellites that are found. The
television will show the number of channels and radio stations that are found.
IM_ODL40450_SAT_A141030_V03_HR.indb 39
39
EN
30/10/14 6:13 PM