Proline CO20W2 Manual Del Usuario página 51

1. Place the heater on a flat, dry and clean floor.
• Position the heater upright on the floor, at least 1 m away from the wall,
away from curtains, furniture or wall coverings.
2. Plug in the heater.
3. Turn the thermostat knob clockwise to the "MAX" position.
4. Turn the heat level control knob to the "III" position (high heat level).
• If you want to lower the room temperature, turn this knob to the "I" (low
heat level) or "II" (medium heat level) position and turn the thermostat
knob slowly in an anticlockwise direction towards to the minimum
position.
5. When not in use, turn the heat level control knob to the 0 ("OFF") position
and then unplug the heater from the mains socket.
Overheat safety protection
Your heater is fitted with a safety device to switches off the heater in the
event of overheating.
Should the overheat protection be triggered, switch off and unplug the heater
from the mains socket. Let the heater completely cool and inspect for blocakge
of air inlet or outlet. Then plug in and press the power switch again and operate
as normal.
If the heater fails to operate or the safety device switches the heater off again,
return heater to your nearest service center for examination or repair.
48
CO20W-IB.indd 48 CO20W-IB.indd 48 19/5/2023 10:53 AM 19/5/2023 10:53 AM