Publicidad
Idiomas disponibles
Idiomas disponibles
PURGE
TRANSMISSION
_tbCAUTION:
Never engage or disengage
freewheel
lever while the engine is running.
To ensure proper operation
and performance,
it is recommended
that the transmission
be
purged before operating
tractor
for the first
time. This procedu re wilt re move any trapped
air inside the transmission
which may have
developed
during shipping
of your tractor°
IMPORTANT:
Should
your transmission
require removal for service
or replacement,
it should be purged after reinstallation
before
operating
the tractor.
1.
Place tractor safely
on a level surface
-
that is clear of objects
and open - with
engine off and parking
brake set.
2.
Disengage
transmission
by
placing
freewheel
control in disengaged
position
(See "TO TRANSPORT"
in this section
of manual).
3.
Sitting
in the tractor
seat, start engine.
After the engine is running,
move throttle
control
to slow
position.
With
motion
control
lever in neutral
position,
slowly
disengage
clutch/brake
pedal
A_!_CAUTION;
At any time, during
step 4,
there may be movement
ofthe drive wheels_
4.
Move motion control lever to full forward
position
and hold for five (5) seconds°
Move lever to full reverse
position
and
hold for five
(5) seconds.
Repeat
this
procedure
three (3) times_
5,
Move
motion
control
lever
to neutral
position_ Shutoff engine and set parking
brake.
6.
Engage
transmission
by placing
free-
wheel control
in engaged
position
(See
"TO TRANSPORT"
in this section
of
manual).
7. Sitting
in the tractor
seat, start engine.
After the engine is running,
move throttle
control to half (1/2) speed° With motion
control
lever in neutral
position,
slowly
disengage
clutch/brake
pedal.
8.
Slowly move motion control leverforward,
after the tractor
moves
approximately
five (5) feet, slowly move motion control
lever to reverse position. After the tractor
moves approximately
five (5) feet return
the motion
control
lever to the neutral
position.
Repeat this procedure
with the
motion control lever three (3) times_
Your transmission
is now purged
and now
ready for normal
operation.
MOWING
TIPS
. Tire
chains
cannot
be used
when
the
mower housing
is attached
to tractor.
• Mower should be properly
leveled for best
mowing
performance_
See "TO LEVEL
MOWER
HOUSING"
in the Service
and
Adjustments
section
of this manual.
• The
left hand side of mower
should
be
used for trimming.
• Drive so that clippings are discharged
onto
the area that has already
been cut. Have
the cut area to the right of the tractor. This
will result in a more
even distribution
of
clippings
and more uniform
cutting,
• When mowing large areas, start byturning
to the right so that clippings
wil! discharge
away
from
shrubs,
fences,
driveways,
etc. After one or two rounds,
mow in the
opposite
direction
making left hand turns
until finished.
f
• If grass
is extremely
tall, it should
be
mowed twice to reduce load and possible
fire hazard
from dried
clippings.
Make
first cut relatively
high; the second to the
desired
heighL
• Do not mow grass when
it is wet.
Wet
grass will plug mower and leave undesir-
able clumps.
Allow
grass to dry before
mowing.
• Always
operate
engine
at full throttle
when
mowing
to
ensure
better
mow_
ing performance
and proper
discharge
of material
Regulate
ground
speed
by
selecting
a low enough speed to give the
mower cutting performance
as well as the
quality of cut desired.
• When
operating
attachments,
select
a
ground speed that will suit the terrain and
give best performance
of the attachment
being used.
15
Publicidad
