Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Make sure tires are properly
inflated
to the
PSt shown on tires.
If tires are over or under
inflated, it may affect the appearance
of your
lawn and lead you to think the mower is not
adjusted
properly.
VISUAL
SIDE-TO-SIDE
ADJUSTMENT
1. With all tires properly
inflated and if your
lawn appears
unevenly
cut, determine
which side of mower is cutting
lower.
NOTE:
As desired,
you can raise the !ow
side of mower or lower the high side.
2.
Go to side of mower you wish to adjust°
3. With a 3/4" or adjustable
wrench,
turn
lift link adjustment
nut (A) to the left to
lower the mower, or, to the right to raise
the mower.
Turn nut rig
to raise mower
Turn nut left
to lower mower
NOTE: Each full turn of adjustment
nut will
change
mower height about 3/1 6'L
44 Test your adjustment
by mowing
some
uncut grass
and visually
checking
the
appearance.
Readjust,
if necessary,
until
you are satisfied
with the results.
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1. With atltires properIy inflated, park tractor
on level ground or driveway_
_I_ CAUTION:
Blades
are sharp.
Protect
your hands with gloves and/or
wrap
blade
with heavy cloth.
2, Raise mower to its highest
position.
3.
At both sides of mower, position
blade at
side and measure
the distance
(A) from
bottom edge of blade to the ground. The
distance should bethe sameon both sides.
4_ If adjustment
is necessary,
see steps 2
and 3 in Visual Adjustment
instructions
above.
5.
Recheck measurements,
adjustifneces-
sary until both sides are equal.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck
must
be level
side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted
so the front tip is
1/8" to 1/2" lower than the rear tip when the
mower is in its highest
position.
CAUTION:
Blades
are sharp.
Protect
your hands with gloves
and/or
wrap blade
with heavy cloth.
• Raise mower to highest
position°
- Position
any blade so the tip is pointing
straight forward.
Measure
distance
(B) to
the ground at front and rear tip of the blade.
• If front tip of blade is not 1/8" to 1/2" lower
than the rear tip, go to the front of tractor.
• With
an 11/16"
or adjustable
wrench,
loosen
jam nut A several
turns to clear
adjustment
nut B.
. With a 3/4" or adjustable
wrench,
turn
front
link adjustment
nut (B) clockwise
(Itighten)
to raise the front of mower,
or,
counterclockwise
(loosen)
to lower
the
front mower_
Tighten adjust nut
B to raise mower
23
Loosen adjust
nut B to lower
mower
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut
wilt change
mower height
about 1/8"o
• Recheck
measurements,
adjust if neces-
sary until front tip of blade is 1/8" to 1/2"
lower than the rear tip.
. Hold adjustment
nut in position with wrench
and tighten jam nut securely
against
ad-
justment
nut,
Publicidad
