Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 1
Install Feed Water Adapter
1. Shut o your under the sink cold water
supply valve.
2. Turn on the kitchen faucet to release
the water pressure.
3. Disconnect the cold water pipe and attach
the "Feed Water Adapter" (J) onto the cold
water supply valve.
STEP 2
Install Royal Prestige
!
Note: If your kitchen sink or countertop
does not have an existing hole, you will
have to drill one. Refer to "Drilling a Hole
in Your Countertop" on page 14 and 15 in
the User Manual.
1. Push the "Faucet Spout" into the "Faucet Body"
until all three black gaskets are fully inserted.
2. Insert the "Faucet Stem," "Faucet Power Cord,"
and "Blue PE Tubing" (K) into the hole in
the countertop.
3. Under the sink, slip on the "Mounting Nut" and
tighten.
STEP 3
Install the Drain Bracket
1. Select a position as high as possible on the vertical drainpipe and drill a 1/4" hole.
2. Slip the front plate on one end of the "Red PE Tubing" and insert the tubing
into the drilled hole about 0.6."
3. Position the back plate on the "Drainpipe" by tightening the screws and nuts
evenly while leaving the tubing in the hole. Insert "Small Blue Lock Clip."
FrescaFlow Faucet
®
Feed Water
Adapter
Faucet Body
Faucet Stem
3/8" Cold Water Pipe
White PE Tubing
Cold Water Supply
Faucet Spout
Countertop
Mounting Nut
Publicidad
