Publicidad
Idiomas disponibles
Idiomas disponibles
Tighten adjust nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut will change
mower
height
about
1/8".
+ Recheck
measurements,
adjust
if nec-
essary
until front tip of blade
is 1/8" to
1/2" lower
than the rear tip.
.
Hold adjustment
nut in position
with
wrench
and tighten
jam nut securely
against
adjustment
nut.
TO REPLACE
MOWER
DRIVE
BELT
MOWER
DRIVE
BELT REMOVAL
1.
Park tractor
on a level surface.
Engage
parking
brake.
2.
Lower
attachment
lift lever to its lowest
position.
3.
Disengage
belt tension
rod (K) from
_l_ock
bracket
(L).
CAUTmON:
Belt tension
rod is spring
loaded.
Have a firm grip on rod and re-
lease
slowly.
4.
Remove
screws
(P) from R.H. and LH.
mandrel
covers
and remove
covers
(Q).
5.
Remove
any dirt or grass
clippings
which
may have accumulated
around
mandrels
and entire
upper
deck sur-
face.
6.
Remove
belt from electric
clutch
pulley
(M), both mandrel
pulleys
(R) and all
idler pulleys
(S).
MOWER
DRIVE
BELT INSTALLATION
1.
Install
belt around
both mandrel
pul-
leys (R) and around
idler pulleys
(S) as
shown.
2.
Install
belt onto electric
clutch
pulley
(M).
IMPORTANT:
Check
belt for proper
rout-
ing in all mower
pulley
grooves.
3.
Reassemble
R.H. and LH.
mandrel
covers
(Q). Securely
tighten
all screws.
4.
Engage
belt tension
rod (K) on locking
bracket
(L).
_, CAUTION:
Belt tension
rod is spring
loaded.
Have a tight grip on rod and en-
gage slowly.
5.
Raise
attachment
lift lever to highest
position.
26
Publicidad
