Descargar Imprimir esta página

Craftsman 917.28746 Manual Del Operador página 27

Publicidad

Idiomas disponibles

Idiomas disponibles

TO ADJUST
ATTACHMENT
CLUTCH
The electric
clutch
should
provide
years
of service.
The clutch
has a builtqn
brake
that stops
the pulley
within
5 seconds.
Eventually,
the internal
brake
will wear
which
may cause
the mower
blades
to
not engage,
or, to not stop as reqwred.
Adjustments
should
be made
by a Sears
or other
quaIMed
service
center.
1.
Make sure attachment
clutch
and igni-
tion switches
are in "OFF"
position.
2.
Adjust
the three
nylon
Iocknuts
until
space
between
clutch
plate and rotor
measures
.012" at all three
slot loca-
tions cut in the side of brake
plate.
NOTE:
After
installing
a new electric
clutch,
run tractor
at full throttle
and
engage
and disengage
electric
clutch
10
cycles
to wear
in clutch
plate.
Rotor
.012"
1
Nylon_i
Slot (3)
1
Locknut
_--- ..........................................................................................
L :: :-:_Plate
TO REPLACE
MOTION
DRIVE
BELT
Park the tractor
on level surface.
Engage
parking
brake.
For ease
of service
there
is
a belt installation
guide
decal
on bottom
of
left footrest.
BELT
REMOVAL-
1.
Remove
mower
(See "TO REMOVE
MOWER"
in this section
of manual).
NOTE:
Observe
entire
motion
drive
belt
and position
of all belt guides
and keepers.
2.
%sconnect
clutch
wire harness
(A).
3.
Remove
antiorotation
link (B) on right
side of tractor.
4.
Remove
belt from stationary
idler (C)
and clutching
idler (D).
5.
Remove
belt from centerspan
idler (E).
6.
Pull belt slack
toward
rear of tractor.
Carefully
remove
belt upwards
from
transmission
input
pulley
and over
cooting
fan blades
(F).
7.
Remove
belt downward
from engine
pulley
and around
electric
clutch
(G).
8.
Slide
belt toward
rear of tractor,
off the
steering
plate
(H) and remove
from
tractor.
BELT
INSTALLATION
-
1.
Install
new bek from tractor
rear to
front,
over the steering
plate
(H) and
above
clutch
brake
pedal shaft
(J).
2.
Pull belt toward
front of tractor
and roll
belt around
electric
clutch
and onto
engine
pulley
(G).
3.
Pull belt toward
rear of tractor.
Care°
fully work
belt down
around
transmis°
sion cooling
fan and onto the input
pulley
(F). Be sure
belt is inside
the
belt keeper.
4.
Install
belt on centerspan
idler (E).
5.
Install
belt through
stationary
idler (C)
and clutching
idler (D).
6.
Reinstall
antiorotation
link (B) on right
side of tractor.
Tighten
securely.
7.
Reconnect
clutch
harness
(A).
8.
Make sure
belt is in all pulley
grooves
and inside
all belt guides
and keepers.
9.
Install
mower
(See "TO INSTALL
MOWER"
in this section
of manual).
27

Publicidad

loading