Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
1. Problem: No LED lit.
Possible Cause: AC end is not making a good connection.
Solution: Check for poor connection at AC side.
2. Problem: Green LED keeps blinking.
Possible Cause: Clamps are not making a good
connection.
Solution: Check for poor connection at battery and frame.
3. Problem: Yellow LED illuminated right away when
connecting onto a battery.
Possible Cause:
a. Incorrect battery voltage.
b. Battery is at full charge capacity
Solution:
a. Determine if the battery is a 12V battery. The
charger will give you a warning if you are
connecting to the incorrect application.
b. The battery is currently at full charge and will
continue in maintenance/float mode until voltage drop
occurs. At the time of voltage drop, charger will resume
in maintenance charging mode.
NOTE that if the troubleshooting cannot fix the issue you have,
please contact the distributor for the information.
WARNING: Keeping the battery attached to the charger without
AC power could unintentionally discharge the battery.
- 13 -
Publicidad
