MELICONI HP FLASH EVO Instrucciones De Uso página 16

The "HP FLASH EVO" wireless TV headset allows you to:
- listen to TV wirelessly
- automatically switch to receive a call while listening to TV
- listen to music from smartphones/tablets/stereos equipped with Bluetooth technology
- make calls with your smartphone without using your hands (hands-free function)
- listen to the TV even if the battery has run out or from sources that do not have a Bluetooth® interface
(audio cable mode).
CAUTION: Do not wear the headset while charging the battery
Before using the headset, recharge it fully (approx. 2h)
• Insert the USB type C connector of the supplied cable into the USB-typeC charging socket [7].
• Plug the other end of the USB cable into an available USB port of an approved charger.
• When the headset is charging, the LED indicator [4] remains solidly lit in red.
• When the headset is fully charged, the LED indicator [4] remains lit solid blue.
• When the battery is low and needs recharging, an audible warning tone will be heard in the headset.
1. The first time you use the HP FLASH EVO headset with a Bluetooth® -enabled TV you need to perform the
Pairing operation. Press the ON/OFF button [5] for about 3 seconds: the LED [4] will start flashing blue and
red alternately.
2. Activate the Bluetooth® Device Search function on the TV.
3. On the TV, check the list of Bluetooth® devices found and search for "HP FLASH EVO".
4. Follow the instructions on the TV's screen to pair it with the HP FLASH EVO headset (Check the TV's user
manual for more details)
5. Once pairing is complete, the headset will automatically connect to the TV if it is turned on and within range of
its Bluetooth® (approximately 10 metres)
Pairing the headset with your mobile phone
1. When using the HP FLASH EVO headset with a Bluetooth® phone for the first time, you must perform the
Pairing operation. Press the ON/OFF button [5] for about 3 seconds: the LED [4] will start flashing blue and
red alternately.
2. Activate the Bluetooth® Device Search function on your phone. Check that your phone has the "visible to all"
option activated.
3. On your phone check the list of Bluetooth® devices found and search for "HP FLASH EVO".
4. Follow the instructions on your phone's screen to pair it with the HP FLASH EVO headset (Check your phone's
user manual for more details)
5. If a password is required, enter "0000" (4 times zero, not necessary for recent devices).
6. Once pairing is complete, the headset will automatically connect to your phone if it is turned on and is within its
Bluetooth® range (approximately 10 metres)
Turning the headset on and off (after first pairing)
1. Turn the headset on by pressing the ON/OFF button [5] for approx. 3 seconds until the blue LED [4]
lights up (headset beeps)
2. Turn the headset off by pressing the ON/OFF [5] button for approximately 3 seconds until the LED [4]
lights up red and then turns off (headset emits the off tone)
The headphone is equipped with three types of sound equalisation (EQ):
1. Bass mode;
2. Pop Mode;
3. Vocal Mode
To change the EQ mode, simply click the [5] EQ button; an audible tone confirms the change to the
next mode
16
Presentation
Charging the battery
Pairing the headset with the TV
EQ Mode