Using Auto Setting; Using Rev Setting; Cleaning - EASYHOME MA 501-I Manual Del Usuario

Cleaning

2. Ensure that the shredder is seated firmly on the waste bin (see fig. B).
3. Plug the shredder's mains lead

Using AUTO setting

You can shred your paper with the Auto setting.
1. Place the slide switch
and the shredder is ready for use.
2. Feed the paper through the slot
the paper in straight and centred (see fig. B).
If the slide switch is at AUTO, the shredder switches off automatically as soon as
the paper has been shredded.
3. Place the slide switch at OFF, if you no longer need the shredder. The ON LED
goes out.
4. Unplug the shredder and empty the waste bin.
There is a paper sensor
the paper inserted and activates the cutters in the shredder. For
this reason, always push smaller paper formats into the centre of
the slot
Using the REV setting
Use the REV setting to put the cutters into reverse.
1. Move the slide switch into the REV
moves the fed paper back out of the shredder.
2. Take the paper out of the shredder in order then to continue with the
shredding process (see "Paper jam" in the fault table).
Cleaning
WARNING!
Risk of short circuit!
Water that has penetrated the housing may cause a short
circuit.
− Disconnect the power plug before cleaning.
− Never submerge the paper shredder in water.
14
in.
3
at the AUTO position. The ON LED
1
into the cutters. Make sure that you push
5
5
.
6
position. The cutters run in reverse and
1
in the centre of the slot, which detects
Strip Cut Paper Shredder
comes on green
2