Fault table
Fault table
Fault
A paper jam
is blocking
the paper shred-
der.
The
shredder
fails to switch
off automatically
16
Cause
Too much paper
was fed
into the cutters.
There is
paper residue
under the
paper sensor
.
6
Correction
- Move the slide switch into the REV
position. The cutters run in reverse and
moves the paper back out of the slot.
- Reduce the amount of paper and
switch back to AUTO.
- Reduce the amount of paper and
switch back to AUTO.
- Unplug the shredder and then remo-
ve the paper residue by hand.
Do not move the slide switch
REV to AUTO, as the shredder cannot
then be switched off.
− Feed another sheet of paper into the
slot
to clear the blockage.
5
Unplug the shredder. Carefully remove
the pieces of paper from the slot
tweezers or a similar device. Please be
careful not to damage the cutters.
Strip Cut Paper Shredder
1
3
from
1
with
3