Statim 2000 / 5000 G4 - Stopping A Cycle - SciCan STATIM 2000 G4 Manual Del Operador

5 Using your STATIM
If the screen displays a CYCLE FAULT code or a NOT STERILE message, the cassette contents are not
sterile. See Section 10 Troubleshooting for more information.
5.5 STATIM 2000 / 5000 G4 — Stopping a Cycle
To stop a cycle press the STOP button. If the STOP button is pushed, the cassette is removed, or the unit
detects a problem while operating, the cycle will stop. Once a cycle has been stopped, the STOP button
must be pressed before another cycle can be started. The display reads any of the following messages:
or
If the display shows the message, CYCLE FAULT or NOT STERILE, the cassette contents are not sterile!
See Section 10 Troubleshooting for more information.
If the cassette contains wrapped instruments and the wraps are not dry when the cassette is open, the
instruments must be handled in an aseptic manner for immediate use and should not be stored.
Page 36