Descargar Imprimir esta página

Infiniton CMPE-64ABL Manual De Instrucciones página 25

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance and cleaning
Carbon filter - not supplied
Activated carbon filter can be used to trap odors. Normally the activated carbon filter should be
changed eyery 3 to 6 months according to your cooking habits. The installation procedure of activated
carbon filter is as below:
1. Before installing or replacing the carbon filters, disconnect the
mains power to the unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both sides of the motor anti-clockwise.
Replace thecarbon filters with the new carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
Note: Make sure the filter is securely locked. Otherwise, it would loosen and cause danger.
When activated carbon filter attached, the suction power will be lowered.
Bulb replacement
IMPORTANT!
Note: Before changing the lights, make sure that the appliance isturned
off and unplugged.
Protect against danger when changing lights, such as wearing gloves.
1. Disconnect the appliance from the mains or turn off the circuit breaker.
2. Remove the metal filters (see Cleaning and replacing filters).
3. Remove the light by pulling its connector out of the housing body (this
may require pressure or force) and disconnect the connector from the
light.
4. Replace the light with a new light of the same type, making sure to
connect the light correctly to the light cable.
5. Fit the metal filter in place.
- The ILCOS D-code for this lamp is DSR-1.5-S-33.2/120.
- LED modules - round lamp
- Maximum power: 1×1,5W
- Rated voltage: 220V-240V
- Dimensions: Square/Diameter: 33.2 x 120mm
The bulb must be replaced by the manufacturer, its service agent or
similarly qualified persons.
Always switch off the electricity supply before carrying out any operations
on the appliance. When handling bulb, make sure it has completely cooled
down before any direct contact with hands.
When handling bulbs hold with a cloth or gloves toensure perspiration does
not come in contact with the bulb as this can reduce the life of the bulb.
25
English
infiniton.es

Publicidad

loading