Publicidad
HOW TO INSTALL BATTERIES
1. Open the battery door with a screwdriver (A). If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install
batteries using sharp or metal tools. 2. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment. 3. Replace battery door securely. Check your local laws
and regulations for correct recycling and/or battery disposal.
HOW TO CHARGE
1. Turn the vehicle off. 2. Remove the cover from the charging cable compartment. 3. Plug the charging cable into a computer or wall adapter. 4. Light inside cab indicates charging. Solid for
charging and off when fully charged.
HOW TO DRIVE
1. Turn on the vehicle and place on a flat surface. 2. Push the throttle lever up to the maximum position (1) and back to minimum position (2) to complete the connection. 3. You are ready to
drive. 4. Use the remote control to drive.
For TROUBLESHOOTING questions and solutions, please visit our website: MONSTERJAMRC.COM
NOTE: If normal function of the product is disturbed or interrupted, strong electromagnetic interference may be causing the issue. To reset product, turn it completely off, then turn it back
on. If normal operation does not resume, move the product to another location and try again. To ensure normal performance, change the batteries, as low batteries may not allow full
function.
Safety Precautions: - Keep hands, hair and loose clothing away from the motor/ wheels when power switch is turned ON. - Remove battery(s) from controller when not in use. - Parental
guidance is recommended for the play. - Keep your toy in your sight so that you can supervise it all the time. - New alkaline batteries are recommended for use in controller to obtain
maximum performance. - Users should keep strict accordance with the instruction manual while operating the product.- Your remote/charger is tailor-made for the LiFeP04 rechargeable
battery used in your vehicle. Do not use it to charge any battery other than that in the toy. Note: Parental guidance is recommended when installing or replacing batteries. Under the
environment with electrostatic discharge, the toy may malfunction and require user to reset the toy.
Special note to adults: Regularly examine for damage to the plug, enclosure and other parts. In the event of any damage, the toy must not be used with the charger until the damage has
been repaired. This toy is not intended for children under 3 years old. This toy must only be used with the recommended charger.
CONTAINS 1 x 6.4V LiFe BATTERY PACK AND REQUIRES 2 x 1.5V AAA (R03) BATTERIES (INCLUDED).
Batteries or battery packs must be recycled or disposed of properly. When this product has reached the end of its useful life, it should not be disposed of with other
household waste. The Waste Electrical and Electronic Equipment Regulations require it to be separately collected so that it can be treated using the best available
recovery and recycling techniques. This will minimize the impact on the environment and human health from soil and water contamination by any hazardous substances,
decrease the resources required to make new products and avoid using up landfill space. Please do your part by keeping this product out of the municipal waste stream! The "wheelie bin"
symbol means that it should be collected as "waste electrical and electronic equipment". You can return an old product to your retailer when you buy a similar new one. For other options,
please contact your local council.
PRODUCT BATTERY REMOVAL INSTRUCTIONS:
Internal battery is factory installed and non-replaceable. Product disassembly and battery removal must be performed by an adult. Do not puncture, cut, tear, compress or deform product
during disassembly. Ensure product is turned off, then use a screw driver to remove screw. Lift end of battery compartment and slide out battery. Dispose of battery in accordance with your
local battery recycling or disposal laws.
NOTE: Opening of product will render product inoperative and voids manufacturer warranties. Dispose of remaining product components in accordance with local laws.
This toy is equipped with a LiFePo battery.
SPECIAL LiFe BATTERY INSTRUCTIONS: Never charge battery unattended. - Charge battery in an isolated area. Keep away from flammable materials. - Do not expose to direct sunlight.
There is a risk of the batteries exploding, overheating, or igniting. - Do not disassemble, modify, heat, or short-circuit the batteries. Do not place them in fires or leave them in hot places. - Do
not drop or subject to strong impacts. - Do not allow the batteries to get wet. - Only charge the batteries with the specified Spin Master™ battery charger. - Only use the batteries in the
device specified by Spin Master™. - Carefully read the instruction guide and use the batteries correctly. - In the unlikely event of leakage or explosion use sand or a chemical fire extinguisher
for the battery. - Batteries must be recycled or disposed of properly.
CARE AND MAINTENANCE: Always remove batteries from the toy when it is not being used for a long period of time (remote only). Wipe the toy gently with a clean damp cloth. Keep the
toy away from direct heat. Do not submerge the toy in water. This can damage the electronic assemblies.
BATTERY SAFETY INFORMATION: Requires 2 x 1.5 V AAA (R03) batteries (included). Batteries are small objects. Replacement of batteries must be done by adults. Follow the polarity (+/-)
diagram in the battery compartment. Promptly remove dead batteries from the toy. Dispose of used batteries properly. Remove batteries for prolonged storage. Only batteries of the same or
equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries
or types of batteries (i.e. alkaline/standard/rechargeable). Using rechargeable batteries is not recommended due to possible reduced performance. Rechargeable batteries are only to be
charged under adult supervision. Replaceable-rechargeable batteries are to be removed from the toy before being charged. DO NOT recharge non-rechargeable batteries. DO NOT
short-circuit the supply terminals.
e
4
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This
device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for Class B
digital devices pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference to radio communications. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction, may cause harmful interference to radio communication. However,
there is no guarantee that interference will not occur in a particular installation. If this toy does cause interference to radio or television reception (you can check this by turning the toy off and
on while listening for the interference), one or more of the following measures may be useful:
• Reorient or relocate the receiving antenna.
• Increase the separation between the toy and the radio or the TV.
• Consult the dealer or an experienced TV-radio technician for help.
NOTE: Changes, adjustments or modifications to this unit, including but not limited to, replacement of any transmitter component (crystal, semiconductor, etc) could result in a violation of
FCC rules under part 15 and/or 95 and must be expressly approved by Spin Master Ltd or they could void the user's authority to operate the equipment.
CAN ICES-3(B)/NMB-3(B)
CANADIAN Class B statement: This device complies with Industry Canada Licence-exempt RSS's. Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Do not change or modify anything on the toy.
Before first use: Read the user's information together with your child.
IMPORTANT INFORMATION: Remove all packaging before use. Retain this information, addresses and phone numbers for future reference. Content may vary from pictures. An adult
should periodically check this toy to ensure no damage or hazards exist, if so, remove from use. Children should be supervised during play. Keep away from obstacles and electrical hazards.
Spin Master Ltd. reserves the right to discontinue the www.monsterjamrc.com website at any time.
INSTALLATION DES PILES
1. À l'aide d'un tournevis, ouvrir le couvercle du compartiment des piles (A). Si des piles usagées sont présentes, les extraire en tirant sur l'une des extrémités. NE PAS utiliser d'objet
coupant ou métallique pour extraire ou installer les piles. 2. Installer des piles neuves comme indiqué sur le schéma de polarité (+/-) du compartiment des piles. 3. Bien refermer le
compartiment des piles. Consulter la législation locale concernant le recyclage et/ou l'élimination des piles.
MISE EN CHARGE
1. Éteindre le véhicule. 2. Retirer le couvercle du compartiment du câble de charge. 3. Insérer le câble de charge dans un ordinateur ou un adaptateur mural. 4. Lorsque le voyant à l'intérieur
de la cabine reste allumé, cela indique que la batterie est en charge. La batterie est chargée lorsque le voyant s'éteint.
CONDUITE
1. Mettre le véhicule en marche et le poser sur une surface plane. 2. Pousser sur la commande d'accélération jusqu'à la position maximale (1) puis de nouveau jusqu'à la position minimale (2)
pour effectuer la connexion. 3. Le véhicule est prêt à être utilisé. 4. Utiliser la radiocommande pour piloter le véhicule.
En cas de PROBLÈME, consulter le site Internet à l'adresse : MONSTERJAMRC.COM
REMARQUE : De fortes interférences électromagnétiques peuvent perturber ou interrompre le fonctionnement normal du produit. Pour le réinitialiser, l'éteindre complètement et le rallumer.
Si le produit ne fonctionne toujours pas normalement, changer de lieu d'utilisation et réessayer. Des piles faibles peuvent empêcher le produit de fonctionner correctement. Pour des
performances optimales, remplacer les piles.
Mesures de sécurité : - Maintenir les mains, cheveux et vêtements amples à l'écart du moteur/des roues lorsque l'interrupteur est placé sur ON. - Retirer les piles de la radiocommande
lorsqu'elle n'est pas utilisée. - La surveillance des parents est recommandée pendant l'utilisation. - Toujours garder le jouet dans le champ de vision pour le surveiller à tout moment. - Pour
des performances optimales, il est recommandé d'utiliser des piles alcalines neuves dans la radiocommande. - Les utilisateurs du produit doivent scrupuleusement respecter les consignes de
ce mode d'emploi. - La radiocommande/chargeur a été conçue spécialement pour être utilisée avec la batterie LiFeP04 rechargeable du véhicule. Ne pas l'utiliser pour recharger une autre
batterie. Remarque : Il est recommandé aux parents d'aider les enfants lors de l'installation et du remplacement des piles. Les décharges électrostatiques peuvent perturber le fonctionnement
du jouet et conduire l'utilisateur à le réinitialiser.
Remarque à l'attention des adultes : Vérifier régulièrement que la prise, la structure et les autres pièces ne présentent aucun dommage. S'il est endommagé, le chargeur ne doit pas être
utilisé avec le jouet tant qu'il n'est pas réparé. Ce jouet ne convient pas aux enfants de moins de 3 ans. Ce jouet ne doit être utilisé qu'avec le chargeur recommandé.
CONTIENT 1 BATTERIE LiFe 6,4 V ET FONCTIONNE AVEC 2 PILES AAA (R03) 1,5 V (FOURNIES).
Les piles ou les batteries doivent être correctement recyclées ou éliminées. Lorsque ce produit arrive en fin de vie, il ne doit pas être jeté avec le reste des déchets
ménagers. Conformément à la directive sur les Déchets des équipements électriques et électroniques (DEEE), il doit être collecté séparément afin d'être éliminé selon
les meilleures techniques de récupération et de recyclage disponibles. Cette démarche réduit les risques de pollution du sol et des eaux, et permet ainsi de minimiser
l'impact de toute substance nocive sur la santé et sur l'environnement. Cela diminue également la quantité de ressources nécessaires à la fabrication de nouveaux
produits, et évite la saturation des sites d'enfouissement. Veuillez apporter votre contribution en ne jetant pas ce produit avec les déchets de votre commune. Le symbole de la « poubelle sur
roues » signifie que ce produit doit faire l'objet d'une collecte respectant la directive sur les Déchets des équipements électriques et électroniques (DEEE). Vous pouvez également retourner
les produits en fin de vie à votre détaillant lors de l'achat d'un produit similaire neuf. Pour plus d'informations, contactez votre commune.
f
5
Publicidad
