Publicidad
Idiomas disponibles
Idiomas disponibles
™
|
Polaris
®
Forza
Pump
Owner's Manual
Section 1. IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS
All electrical work must be performed by a licensed electrician or qualified pool service professional and conform to all
national, state, and local codes.
always be followed, including the following:
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS INJURY
OR DEATH. Do not block pump suction, as this can cause severe injury or death. Do not use this pump for wading
pools, shallow pools, or spas containing bottom drains. Suction outlet (drain) assemblies and their covers must be
certified to the latest published edition of ANSI
To reduce the risk of injury, do not permit children to use this product. All components in the system, such as
pumps, filters, and heaters, etc., shall be positioned so as to prevent their being used as a means of access to the
pool by young children.
To reduce the risk of property damage or injury, do not attempt to change the backwash (multi-port, slide, or full
flow) valve position with the pump running.
Polaris pumps are powered by a high voltage electric motor and must be installed by a licensed or certified
electrician or a qualified swimming pool service technician.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a grounding type
receptacle that is protected by a ground-fault circuit-interrupter (GFCI), Class A GFCI in Canada. Contact a
qualified electrician if you cannot verify that the circuit is protected by a GFCI. Make sure such a GFCI should
be provided by the installer and should be tested on a routine basis. To test the GFCI, push the test button. The
GFCI should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate in this
manner, the GFCI is defective. If the GFCI interrupts power to the pump without the test button being pushed, a
ground current is flowing, indicating the possibility of electrical shock. Do not use the pump. Disconnect the pump
and have the problem corrected by a qualified service representative before using.
Due to the potential risk of fire, electric shock, or injuries to persons, Polaris pumps must be installed in
accordance with the National Electrical Code
safety codes, and the Occupational Safety and Health Act (OSHA
National Fire Protection Association
government inspection agency.
Incorrectly installed equipment may fail, causing severe injury or property damage. DO NOT MODIFY THIS
EQUIPMENT.
To reduce the risk of electric shock, replace damaged cord immediately. If replacement of the plug or cord is
needed, use only identical replacement parts. To reduce the risk of electric shock, do not use extension cord to
connect unit to electric supply; provide a properly located outlet.
• Do not connect the system to an unregulated city water system or other external source of pressurized water
producing pressures greater than 35 PSI.
• Trapped air in system can cause the filter lid to be blown off, which can result in death, serious personal injury, or
property damage. Be sure all air is out of the system before operating.
When installing and using this electrical equipment, basic safety precautions should
WARNING
®
/ASME
®
WARNING
WARNING
WARNING
WARNING
(NEC
®
®
), Canadian Electrical Code (CEC), all local electrical and
(NFPA
®
®
) online at www.nfpa.org or call 617-770-3000, or contact your local
WARNING
WARNING
WARNING
A112.19.8, or its successor standard, ANSI/APSP-16.
). Copies of the NEC may be ordered from the
®
Page 3
ENGLISH
Publicidad
