Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
3
Installing the tub and shower
outlet connections
NOTE: Do not use PEX or CPVC between the valve and
spout.
□
Wrap thread sealant tape around the pipe
threads in a clockwise direction, as shown.
□
Connect the shower (1) and tub outlet pipes (2)
to the valve body (D). Connect the pipe elbows
(3) (not included) to the ends of both pipes,
and tighten with a wrench.
NOTE: For shower-only installation, wrap thread sealant
tape around the threads of the plug (I), and insert it into
the bottom outlet (4).
Shower
1
4
3
Shower
1
D
2
Tub
3
D
I
4
Flushing the water outlets and
checking for leaks
□
For tub and shower combinations, turn on the
hot and cold water supply lines, allowing water
to ow from the tub spout outlet (1) until all
debris is cleared from the line. Check all
connections for leaks.
□
For shower only installations, turn on the hot
and cold water supply lines, allowing water
to ow from the shower outlet (2) until all
debris is cleared from the line. Pressure must
be approximately equal on both hot and cold
sides for the valve to function properly. Check
all connections for leaks.
6
2
1
Publicidad
