Elcometer PP10T Manual De Instrucciones página 8

Do not use the hoses to move the equipment by dragging it. Keep the hoses away from moving parts
and heated surfaces. Do not place them in contact with products that may affect them and do not
expose them to temperatures greater than 65
The unit has been designed for a long service life and can be used with most of the usual products
on the market. Its use with highly aggressive products will quickly increase the need for maintenance
and spare parts. If you need to apply special products, please contact with ELCOMETER.
If the equipment is going to remain for a long time running empty, disconnect it from the general air
network.
ELCOMETER recommends the installation of some sort of SAGOLA air
treatment equipment in the general compressed air network, in order to
optimise the operation of the equipment.
07. Functional description of the equipment
A pressure pot is a stainless steel pressure tank into which the product to be applied is introduced along
with pressurised air. The regulated air transmits the product to the spray gun at a variable pressure of 0
to 7 bar (0 - 101.5 psi) depending on the model. These pressure pots can be used with the majority of
current coating and finishing products and facilitate the spraying of high viscosity products.
When working with water-based products we must ensure that the inside of the pressure pot is
galvanised.
The equipment requires frequent and thorough cleaning.
07.1. Types of regulation
SINGLE REGULATION
The pressure pot will only have one pressure regulator with its
corresponding pressure gauge. This regulator is in charge of
adjusting the internal pressure of the deposit, inside which the
product is located.
Once the pressure of the product has been adjusted, it will flow
to the gun activated by the internal pressure of the pot when
the product outlet valve is opened.
DOUBLE REGULATION
The pressure pot will have two pressure regulators with
their corresponding pressure gauges. The first one, as in the
previous case, is in charge of regulating the internal pressure
of the pot.
The second is responsible for providing the spray gun with air
that can be sprayed. Both regulators are fully independent and
the desired pressure can be adjusted in each one.
EN 06
o o
C or less than –20 C.
PP10TS
PP10T-MA/PP25T/PP50T
www.elcometer.com