Orbegozo HO 150 Manual De Instrucciones página 19

HO 150
INSTALLATION
• After removing the packaging, check the status of the device and if you are unsure, do not use and
ask a qualified professional. The packaging materials (plastic bags, polyethylene foam, nails, etc.)
must be kept away from children as they are potentially dangerous. Dispose according to local
regulations on recycling plastic containers. Please note any warning stickers or materials must be
removed before using the appliance. The manufacturer declines any responsibility if these safe
operating practices are not followed.
• Before connecting the appliance, check that the voltage shown on the nameplate matches the
power supply and the electrical outlet is grounded. In the event of any inconsistency between the
outlet and the appliance plug, have a qualified professional to replace it with another more
appropriate type. This professional will ensure that the cable section is suitable for making the
device. The use of adapters or extension cables is not recommended.
• The electrical outlet must be possible to easily reach the plug can be disconnected quickly in an
emergency.
• Before use, check that the appliance is in good condition and that the power cord does not have
any damage, if in doubt, consult a qualified professional.
• Make sure the cable is seated correctly, which is not in contact with any hot surfaces or sharp edge,
which is wrapped around the device and is not screwed in itself to prevent tipping.
• Place the appliance:
- Keep away from heat sources (eg, other furnaces, gas stoves, etc.), flammable materials (wallpaper,
etc.), explosives (spray cans) materials and materials that can be deformed when heated.
- On a flat, stable work and never on sensitive surfaces (painted furniture, tablecloths, etc.) in a place
where it will not get bumps and adequate distance from the edge so you can not fall.
- Far from containers in which there are liquids, such as sinks, etc. If it accidentally gets wet or falls in
liquid, disconnect the plug from the outlet immediately, allow the appliance to cool, dry well and
make sure that the electrical components are not damp. If in doubt, consult a qualified professional.
• This oven is not designed to be embedded. Place the unit on a level, dry surface, leaving a gap of
20cm on the sides of the oven and 50cm at the top. The back should be placed against the wall. Do
not subject the cabinet. Make sure the door can be opened without being obstructed.
• The pizza can burn, so you should watch the pizza oven while it is toasting.
• If catches fire in any part of the oven, do not attempt to extinguish with water. Extinguish flames
with a damp cloth.
• Be careful not to block the vents. Obstruction of the grids could cause the oven to overheat.
• The appliance must not be placed directly under a power outlet.
• To avoid risk of fire, do not use the appliance with a timer or programmer or a system that can
automatically switch on, as there is a risk of fire if the oven is covered or positioned incorrectly.
• In case of shutdown or failure, switch off and have a professional qualified to review. Repairs
carried out by a person without adequate preparation can be dangerous and void the warranty.
USING THE OVEN
The oven can be adjusted by the following items:
• Thermostat. It regulates the temperature of the oven: turn the dial to the desired temperature; the
heating element is switched on and off once the temperature reached.
• Timer: Set the cooking time.
TMER
Regulates the operation time of the oven: turn the timer knob to the desired cooking time, after
which time the heating elements are turned off. The selector gradually turns to "0", and when it
reaches "0" beeps.
19