Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACH REAR GUIDE RAIL
1. Align the right edge of the rear guide rail
with the right edge of the right extension
wing, see Figure 4.
2. Locate the holes in the rear of the table,
spaced 8 inches right and left of the blade.
Align guide rail holes (A) shown in Figure
4, with those in the table and secure using
the appropriate bolt/screws, washers and
nuts.
3. Use the gauge (B) to ensure the rear guide
rail is parallel with the table.
(RE) ATTACH EXTENSION WING OR WOODEN TABLE SUPPORT
RE-ATTACHING AN EXISTING
EXTENSION WING
If your table saw has an extra extension wing that was
removed when you disassembled the old fence rails,
re-install it now.
ATTACHING AN ADDITIONAL
EXTENSION WING
If you purchased an additional extension wing, install it
now using the hardware included with the fence.
1. Fasten the new wing to the existing wing using three
5/16" x 1 ¼" hex head screws, flat washers, and nuts.
2. Secure the front guide rail to the new wing with flat
5/16" hex head screws.
Table Saw
Width
2-1/4" x 3/4"
Semi-hardwood
ASSEMBLY
12" Centers
(Approx.)
12" Centers
(Approx.)
5/8" or 3/4"
Particle Board
B
FIGURE 4
3. Attach the rear guide rail to the new wing using
hex head bolts, and hex flange nuts.
CONSTRUCTING AND ATTACHING A
WOODEN TABLE SUPPORT
(For use with the DELTA 36-T50 T3 Fence only)
Due to the extended length of the DELTA 36-T50 T3
fence, it is necessary to build a wooden table support
to position and support oversized workpieces.
To build a wooden table support, refer to Figure 5.
Accessory extension table 36-T53 is available for use
with the 36-T50 T3 ONLY.
Length
Desired
Plastic Laminate
6
A
FIGURE 5
Publicidad
