Publicidad
Idiomas disponibles
Idiomas disponibles
TO ADJUST:
1. Lift the fence clamping lever and
remove the fence.
2. Slightly tighten or loosen one of the
two set screws (D) (Figure 13), using a
3mm hex wrench (not supplied).
IMPORTANT: Very little movement of the
set screws is necessary to adjust the
fence.
3. Place the fence on the guide tube and
check the alignment again.
4. Continue to adjust the screws until
the fence edge is parallel to the miter
gauge slot.
SQUARING THE FENCE TO THE TABLE
To reduce the risk of injury, turn unit off and disconnect it from power source before installing
and removing accessories, before adjusting or when making repairs. An accidental start-up can
cause injury.
1. Lock the fence in place on the table.
2. Using a square (A) (Figure 14) placed
against the middle of the fence, check
to see if the fence is perpendicular to
the table.
TO ADJUST:
1. To adjust, locate the two nylon set screws
(A) (Figure 15), on top of the fence.
2. Using a flat-head screwdriver, rotate the
nylon set screws to bring the fence
perpendicular to the table.
3. Re- check the alignment.
4. Continue to adjust the screws until the
fence edge is perpendicular to the table.
OPERATION AND ADJUSTMENTS
FIGURE 14
D
9
FIGURE 13
A
A
FIGURE 15
Publicidad
