nnserting
the
Door
Panels
I. Loosen the Top Trim on the freezer :had fresh
food doors.
o Using a T-20 Torx driver, loosen the two screws
attaching the Top Trim about 1/4" (6 ram).
2, Insert the panels.
,, Lift the Top Trim up I/4" (6 ram) and carefully push
the top fieezer panel in until it slides into the slot
behind the door handled Push the filler panel
(required with some door panels) in behind the
decorator panel. Repeat for flesh food panel. If your
model has a dispenser andlor a Convenience
Center,
this step only applies to the top panels.
3. Insert the bottom
panels {for models with a
dispenser and/or
Convenience
Center).
• Carefully push the panel in until it slides into the slot
behind the door handte_ Push the filler panel (required
with some door panels) in behind the decorator panel.
4. Tighten
the two screws on the Top Trim to 30
in-lbs torque.
5. install the Side Trim. These pieces are tucked
inside the fresh food door handle°
Do not remove the protective film on the outside
of' the Side Trim until the Side Trim is installed.
" Fit the bottom of the Side Trim under the Bottom
Trim as illustrated.
* Hold the Side Trim against the front face of the
decorator panels and fit the Side Trim under the Top
Trim° Make sure the Side Trim is fitted correctly and !
that you are satisfied with the appearance of' all the
parts before pulling the blue tape liner.
6. Secure the Side Trim.
* Place one hand between the two pieces of blue tape
liner and hold the Side Trim firmly against the panels
and the side of the door.
* Pull the top blue tape liner up about 3" (8 ram),
pressing the trim with your hand as the adhesive is
exposed to the door'. Then pull the bottom blue tape
liner down about 3" (8 mm). Follow the tape with
your hand, pressing the trim adhesive against the door_
* Continue pulling the tape liner loose, alternating
between the top and bottom
and pressing the Side
Trim against the door.
7. Remove
the protective
film from
the outside
of
the Side Trim.
Blue
Tape
Liner
Side
Trim
Cut-Out
Side
Trim