Descargar Imprimir esta página

STAMOS SWG-EMP 30L180 Manual De Instrucciones página 14

Elevador magnético manual

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
achieve the working load 30kg/50kg. Other materials or thinner workpieces may not achieve the
working load.
6.Never exceed the rated capacity of the device 30kg/50kg and the Max Pull Off Force is
tested at a static and vertical condition.
7.Avoid sudden jerking or shock force as this will cause the magnets to lose its hold.
8.This item is not designed as a magnetic welding clamp or as a part of an electrical circuit.
9.For safe operation, the bottom surface must always be flat and smooth. If necessary, it is
possible to sand the magnet face smooth with sandpaper. Always file any burrs that would interfere
with full contact.
10.Do not turn on unless in contact with metal, otherwise, there will be a great loss in
magnetic force.
11.An electricity display on the magnet, please charge it when the electricity is less than 15%.
12.If the Green/Red light is still off after your press, it indicates the voltage is too low, please
charge it or change the battery.
13.It is capable of exceptional break away force holding power and exceptionally strong in
shear force as well. Prying force is the least powerful of the holding capabilities and great care must
be used when attempting to use this device with pry force. See illustrations below.
1.
Table Surface
3.
Sliding – less hold
5.
Sideways – less effective
14.After each lift/carry process, press the red "off" button twice quickly because the magnetic
pull force will be reduced after each lift/carry process. By the "off" and "on" process, it can re-
magnetize the workpiece and get the max. magnetic pull force.
3.2.1.
1.Battery packs are shipped in a low charge condition to prevent possible problems. Therefore,
you should charge from them before first use. Please keep the magnet is in Off condition when
charging it.
2.If the charger is not working, please return magnet with all the accessories back to
manufacturer.
3.Make sure the normal household voltage is AC100-240V~ 260mA.
Charging
EN
2.
Pull up – most effective
4.
Steel target
6.
Pry Force – least effective

Publicidad

loading

Productos relacionados para STAMOS SWG-EMP 30L180

Este manual también es adecuado para:

Swg-emp 30s180Swg-emp 50l300Swg-emp 50s300