Publicidad
Idiomas disponibles
Idiomas disponibles
Removing the side cover and
front panel assembly
1.
Remove the cover screws on the rear panel.
2.
Pull the side cover toward the rear panel until its hooks disengage
from the chassis tabs. Set the side cover aside.
3.
Locate the front panel assembly hooks, then lift them until they
disengage from the chassis.
4.
Swing the front panel assembly to the right, until the hinge-like tabs
on the right side of the assembly are exposed.
5.
Remove the front panel assembly, then set aside.
Air duct
Air duct
Chassis tab holes
Chassis tab holes
Installing a CPU
To install a CPU:
1.
Locate the CPU socket on the motherboard.
2.
Press the load lever with your
thumb (A), then move it to the
left (B) until it is released from
the retention tab.
To prevent damage to the
socket pins, do not remove
the PnP cap unless you are
installing a CPU.
4
1
2
1
2
Quick installation guide
Quick installation guide
4
4
4
4
4
Retention tab
Retention tab
A
A
B
B
Load lever
Load lever
3
3
3
Publicidad
