Publicidad
Idiomas disponibles
Idiomas disponibles
4.
For SATA HDD: Connect the SATA
For SATA HDD
signal and power plugs to the
connectors at the back of the
drive.
For IDE HDD: Connect the IDE signal
For IDE HDD
and power plugs to the connectors
at the back of the drive.
Removing the bay covers and reinstalling the
front panel assembly and side cover
If you installed an optical and/or fl oppy disk drive, remove the bay cover(s)
on the front panel assembly before reinstalling it to the chassis. To do this:
1.
Locate the bay cover locks.
2.
Press the locks outward to
release the bay cover.
3.
Push the bay cover inward, then
set it aside.
4.
Follow the same instructions to
remove the 3.5" drive bay cover.
To reinstall the front panel assembly and side cover:
1.
Insert the front panel assembly hinge-like tabs to the holes on the
right side of the chassis.
2.
Swing the front panel assembly to the left, then insert the hooks to
the chassis until the front panel assembly fi ts in place.
3.
Insert the side cover hooks to the chassis top and bottom holes.
4.
Push the side cover to the direction of the front panel until it fi ts in place.
5.
Secure the cover with two screws you removed earlier.
Air duct
Air duct
Chassis tab holes
Chassis tab holes
8
5
4
5
3
Quick installation guide
Quick installation guide
SATA
SATA
1
2
1
2
1
2
2
IDE
IDE
Publicidad
