Publicidad
Idiomas disponibles
Idiomas disponibles
3.2 Control panel
3.2.1 On/Off button
1.
Press the power button to turn on the product.
2.
The power indicator lights up. The default setting for fan speed is "high. The default
humidity setting is 50%. Press the power button again to turn the product off.
3.
The light on the power indicator goes off and the compressor stops immediately.
The fan will stop after 30 seconds.
If the ON/OFF LED indicator flashes red it means that the product is in defrost mode. The
product automatically stops flashing when the defrost mode is completed.
3.2.2 Mode
Press the button to switch between modes.
Auto mode: if the humidity of the room is 3% above the set humidity, the product will
•
turn on. If the humidity of the room is 3% below the set humidity light the product will
not operate. The fan will stop after 30 seconds.
Continuous drying: The product will turn on, but the humidity level cannot be
•
changed.
Sleep mode: If the control panel is not used for more than 10 seconds, the indicators
•
will slowly darken and the ventilation rate will switch from high to low. Press any
button to activate the sleep mode indicator. Press the mode button again to
deactivate sleep mode.
3.2.3 Timer
1.
Press the timer button to enable the 0–12-hour timer function.
2.
One hour is added with each press of the button. The corresponding time is visible
on the display. The timer LED light turns on when the timer is turned on.
3.
When the set time is over, the indicator light turns off again.
4.
Set the timer to '00' to cancel the timer function. The indicator light will turn off
again.
24
If the product is off: set the timer and the product will turn on when the set time is
•
over.
If the product is on: set the timer and the product will turn off when the set time is
•
over.
3.2.4 Humidity level
1.
Press the button to check the humidity level of the room.
2.
Press the button again to set the humidity level. You can set the humidity to 30%,
35%, 40%, 45%, 50%, 55%, 60%, 65%, 70%, 75%, 80%.
3.
After 3 seconds, the setting is confirmed. The current humidity level is displayed on
the screen.
If you set the product to 'continuous drying' the humidity cannot be changed.
•
Press the button for 3 seconds to display the current temperature.
•
3.2.5 Fan speed
1.
Press the button to switch between different ventilation speeds:
•
Fast ventilation
•
Slow ventilation
2.
The corresponding LED indicators light up.
The speed cannot be adjusted if the product is set to continuous drying, sleep mode or
defrost function.
3.2.6 (Child) lock
Press the button for 3 seconds to lock the product.
3.2.7 Full water tank
When the water tank is full, the LED light turns red and the alarm sounds 5 times. Press
any button to turn off the alarm. The compressor and fan will be turned off. The product
cannot be used again until the water tank is emptied and replaced.
English
25
Publicidad
