Tennant IPC PW-H61 Manual De Instrucciones página 23

laws for electric safety. (In compliance
with the provisions of the IEC 60364-1
standard)
- It is necessary to check this essential
safety requisite. In case of doubt, ask for
accurate control of the power system by
qualified personnel.
The manufacturer may not be considered
responsible for damages occurred
because of the lack of the grounding
system.
- The H.P. cleaner must be connected
to the electric supply by means of an
omnipolar switch with opening contacts
of at least 3 mm. This switch must have
electric features which are consistent
with the appliance. (This requisite does
not apply to H.P. cleaners with plug and
electric power lower than 3 kW).
It is recommended that the electric
supply to this machine should include a
residual current device that will interrupt
the supply if the leakage current to earth
exceeds 30 mA for 30 ms or a device that
will prove the earth circuit.
- The appliance is disconnected from
the electric supply only by pulling out
the plug or switching off the omnipolar
switch.
- Failure to respect the above absolves
the manufacturer of all liability and
represents negligent use of the product.
The water cleaner is considered as a
fixed device.
- Water cleaners with the "Total Stop"
device should be considered as off
when the omnipolar switch is in the "O"
position or the plug is unplugged from
the socket.
- The appliance must be attended during
operation. If the water cleaner is left,
even temporarily, turn it off by using the
omnipolar switch or by unplugging the
plug from the socket.
- The high pressure washer is not
intended for use by children, adolescents
or persons with reduced physical,
sensory or mental capabilities, under
the influence of alcohol or lacking
experience and knowledge.
Operators must be made aware of the
instructions for using the appliance by a
person responsible for their safety.
Children must be supervised to ensure
they do not play with the high pressure
washer.
- Use only original accessories that can
allow safe working of the appliance.
- The flexible hose connecting the
lance to the H.P. cleaner must not be
damaged.
In case of damage, replace it immediately.
The hose must be marked with the
admissible pressure value, production
date and manufacturer's name.
- Hoses, connections and fittings for high
pressure systems are very important to
guarantee the safety of the H.P. cleaner.
Use only original spare parts which have
the manufacturer's approval.
- Do not use the H.P. cleaner when
persons or animals are in its of action
field.
EN - english 21