Publicidad
Idiomas disponibles
Idiomas disponibles
CHARGING THE BATTERY
It is recommended to charge new battery before the first use of the electric pruner. Plug the battery charger
output into the battery charging jack then plug the charger into a power socket. The LED indicator on the
battery will turn RED during charging and turn GREEN when the battery is fully charged. The battery takes about
1-2 hours to attain full charge. A fullycharged battery can sustain 1-2 hours of continuous pruning operation.
CAUTIONS
1. During charging, it is normal for the charger and battery to be warm.
2. If the battery is not use for a long period of time, it recommended to charge the battery once every 3
months, this is to ensure the battery life is not affected by low usage.
3. For new battery or battery unused for a long time, it will need about 5 charge-discharge cycles before
achieving full capacity.
4. Do not recharge a fully charged battery just after a few minutes of usage, this will reduce the battery
lifespan and efficiency.
5. Do not use a damaged battery and disassemble the charger or battery.
6. Do not place battery near high temperature heat source, the battery will explode in fire or long exposure
to high temperature heat source.
7. Do not charge the battery outdoor or humid environment.
8. It is normal for the pruning shears to reduce cutting diameter when the battery capacity is getting low.
9. Do not use the pruning shears during charging. It must be disconnected from the battery during
charging.
10. Do not store the battery in a humid environment.
LUBRICATION
all these operations you must disconnect the pruning shears.
FOR
Lubricate at least twice per day (early morning and early afternoon).
For correct lubrication the pruning shear blade must be unlocked. To do this:
1. There is a oil filling port at the reverse of the pruner, take out the cotton.
2. Place the iol bottle nozzle in the lubricating port. Hold the iol bottle up- right and then lubricate.
3. Once lubrication is complete, plug teh cotton.
4. Operate the pruner, make the lubrication is well-proportioned.
It is possible to have a slight movement in the direction of blade closure.
NOTE:
This movement is normal and may be caused by the gap between the rack and
pinion teeth.
The charging is
Charging
completed
Note: The charger is charged in turn, when
the battery is not connected to the power
supply.The light is green, The charging is
completed when the light is green color,
the charger from each charging line has a
corresponding light to indicate the charging
status.
INSTRUCTIONS
EN
35
Publicidad
