Teac T-H300 Manual Del Usuario página 7

Listening to Radio
Broadcast
1 Select AM or FM as you want to listen
to.
2 Select the desired tuning mode.
Manual tuning mode: No indication on
the display.
"AUTO" appears
on the display.
Presettuning mode: "PRESET CH."
appears on the
display.
Auto tuning mode:
3 Tune in the broadcast you want to
listen to by turning the tuning/select
control,
In the preset mode, numeric buttons
and preset call buttons on the remote
control (provided with the TEAC A-H300
amplifier) allow you to tune to the
desired broadcast.
4m broadcasting is set up to STEREO.
If there is any noise in "STEREO", change
the mode to "MONO" by pressing this
button.
Note:
Be sure to turn off the power of the CD
player while listening to broadcasting.
Otherwise, it may cause some noise,
resulting in poor radio reception.
How to Preset
Broadcasting Manually
242
0000000
For example
When you want to preset FM 89.10 MHz to
channel 10.
1 Select the FM broadcasting.
2 Set the frequency to 89.10 MHz by
turning the control either in the manual
tuning mode or auto tuning mode.
3 Press the memory button briefly (for
less 1.5 second).
Then "MEMO" will blink in the display.
> GEE
FM &S iG
4 Select CH"10" by turning the control.
If you don't press the memory button
within 8 seconds after selecting the
channel, the selection will be cancelled.
ca) GED sro
= pata p i e s ?
EM ao it wn
Ce ee ee
5 Press the memory button briefly.
When all the programs are erased
@\f the power has not been supplied for
long (more than about 15 days), all the
Programs you have memorized will be
erased.
1)The power cord is pulled out from the
outlet.
2) The power supply is cut off for long.
In these cases, you must charge
enough electricity (for more than 3
days) after plugging the power cord into
the outlet so that the program may not
be erased even if the cord is pulled out.
How to Preset Broadcasting
Automatically
1 Select the broadcasting band (FM or
AM).
2 Press the memory button long (for more
than 1.5 second).
Then broadcasting will be automatically
received, and as many broadcasting
stations as are received well will be
memorized from channel 1 one after
another.
3 Check the preset broadcast stations.
(1)Select the preset tuning mode by
pressing the tuning mode button.
(2)Turn the tuning/select control.
Notes:
@ In FM automatic memory presetting,
frequency is automatically memorized
twice. The setting which has better
reception will be preset first.
@ If a new broadcast channel is preset to
a channel, the channel which had been
preset to that position earlier will be
automatically erased.
©@ It is impossible to preset automatically
in areas far away from the broadcast
station or in mountain areas where
received signals are weak.
© 30 broadcast stations each for AM and
FM bands can be preset.
Sleep Timer
1. Press the sleep button on the remote
control unit.
- "SL: 10" is shown in the clock display.
- You can engage the sleep timer from 10
minutes to 90 minutes by pressing this
button.
2. If you want to check the sleep time,
press the sleep button once more.
Then the remaining time will be
displayed.
Notes:
@ Each time you press the sleep button,
the sleep preset time is changed as
follows:
SL:10 — SL:20 —* SL:30 — SL:60 +
SL:90 — SL:--
@ "SL:--" indicates the cancellation of
sleep presetting.
ENG