Descargar Imprimir esta página

camry CR 1032 Manual De Uso página 4

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
19. The device is intended for cleaning hard, flat and dry surfaces indoors.It is forbidden to
drive up the skateboard from the slopes, making sharp turns and driving on uneven,
slippery, wet, rapid acceleration and braking.
20. Do not modify the device by youfself as this may cause malfunction of its operation
which in turn may lead to injury and health of the user.
21. User's body weight should be in the range of 20-100 kg. Failure weight can lead to
damage to the equipment which may cause a threat to the health of the user and his
environment.
22. The carrying device objects, even if the weight of the user and transported goods is
within the acceptable range.
23. With skateboards can not be used by people suffering from heart disease,
hypertension, older people with limited knowledge the person is not capable of driving
motor vehicles, pregnant women, people taking strong drugs, under the influence of drugs
(eg. Alcohol, drugs and other ).
24. The use of skateboards requires take precautions such as a helmet, wrist guards,
knee, elbow and others.
25.If the battery is low the device will be a signal tone and a flashing indicator light.
You should then stop driving because the device can not work properly which can lead to
an abrupt halt and collapse.
DESCRIPTION OF THE DEVICE
1. Wheels
4. Switch
CHARGING AND BATTERY REPLACEMENT
Plug the charger into a wall outlet, then insert the small plug it into the charging socket (5) in the device. The first charge should last at
least 2 hours, and the next charges should last until the device is fully charged. A red light on charger signal indicates the start of
charging, the green, finish. Too long charge or no charge for longer than three months reduced battery life.
WARNING!
Do not leave the charger to the device without supervision.
USING THE DEVICE
1. Turn on the device (switch 4)
2. Put the foot on the device (2).If the position will be correct the green lights constantly lit.
3. Tilt forward and back, to start driving (drawing 1 and 2).
4. Stand upright to stop.
5. Step down carefully removing the first one, then the other leg
WARNING!
The safety system will warn you when:
-low battery
-board is tilted more than 10stopni forward or backward
-while driving is felt jerking
-exceed the maximum speed
-rock skateboards will take longer than 30 seconds
-connected charger
-locked wheel drive longer than 2 seconds
-continuous excessive power consumption.
CLEANING AND MAINTENANCE
1. Before cleaning, turn off the skateboard and disconnect it from the charger.
2. Wipe the case with a dry cloth, do not immerse in water.
3. Take cover from the weather.
TECHNICAL DATA
Power supply: 220-240V ~ 50Hz
The total engine power 700W
Charging time: 1.5-2 hours
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
2. Riser
5. charging socket
3. LED lights
4

Publicidad

loading