General Notes; Operation And Maintenance - ZUCCHETTI Robot ORAZIO Manual De Uso

– Before starting the machine, make
sure that the entire area to clean is
free from obstacles (like chairs, ob-
jects weighing less than 5 kg, curtains
and bed covers that touch the floor).
– For models without carpet sensors,
remove any carpets before starting
to operate the machine.
– For models without stair sensors,
block off access to stairs before start-
ing to operate the machine.
– Use only the original detergent, which

GENERAL NOTES

– If the machine is switched on before
the programmed start of cleaning
time, it switches to "pause" mode and
waits until the programmed start of
cleaning time before commencing op-
erations.
To start work immediately, press the
"PAUSE" key.
– During battery charging, the pro-
grammed work cycles are disabled.
They are re-enabled as soon as you
DESCRIPTION OF KEYBOARD CONTROLS
Important
Though the machine is simple to use,
efficient cleaning nevertheless de-
pends on correct programming. Read
these instructions carefully to obtain a
ORAZIO

OPERATION AND MAINTENANCE

has been specially and precisely for-
mulated to give the best possible floor
cleaning results in "wet wipe" mode.
– Clean the brush after every use by
rubbing it against a hard surface to
remove the dirt it has picked up.
– Do not use pressurised water jets to
wash the machine down.
– Do not use solvents or petrol to clean
the machine as these can damage
the paint work.
disconnect the battery charger.
– Check and replace the dust bag fre-
quently. Only use original replacement
bags.
– Do not use the machine without a
dust bag in place.
– The floor cleaning cloth is machine
washable.
– Use the machine at low speed for the
best cleaning results.
clear overview of how to operate and
program the machine.
Whenever you press a key the machine
emits a "beep" to confirm that the key
signal has been processed.
- 9 -
GB
User's manual