Cleaning The Machine; Troubleshooting; Problems, Causes And Solutions - ZUCCHETTI Robot ORAZIO Manual De Uso

CLEANING THE MACHINE

Periodically clean the outside of the ma-
chine with a sponge damped in soapy
water.

PROBLEMS, CAUSES AND SOLUTIONS

The information given below is designed
to help you identify and solve minor prob-
lems that can occur during normal oper-
PROBLEM
Noisy suction.
Intermittent noise repeating
every 1 second or so (10 sec-
onds in wet wipe mode).
The message "RH/LH motor
error" appears on the dis-
play.
The message "Check sum Er-
ror" appears on the display.
The message "Room change"
appears on the display.
The machine switches off
while cleaning.
Nothing appears on the dis-
play but the machine works
normally.
The cloth holder fails to lift
(model with carpet sensors).
ORAZIO
Periodically remove all dust and dirt from
the wheels and brush.

TROUBLESHOOTING

ation. For any problems not dealt with
here, please contact an authorised serv-
ice centre.
CAUSE
The dust bag is full.
The detergent tank is empty.
The rear wheels are locked.
There is a software problem.
The batteries are running
down and the machine is mov-
ing towards a wall power sock-
et.
A failure or danger condition
has been detected.
The display is faulty.
Either the carpet sensors or
the lifting solenoid are faulty.
- 17 -
SOLUTION
Empty or replace the dust bag.
Fill the tank.
Remove the object that is lock-
ing the rear wheels. If the prob-
lem persists, contact a service
centre.
Switch the machine off and
switch it back on again.
Charge the batteries.
Switch the machine back on
again. If the problem persists,
contact a service centre.
Contact a service centre to
have the display changed.
Contact a service centre.
User's manual
GB