Antar AT51039 Manual De Usuario página 5

ENG
ASSEMBLY
1. Raise the top.
2. Unfold horizontally, press the seat from above
until you hear a click.
3. Install the cane / umbrella holder.
4. Assemble the bag.
FOLDING
Reverse the order of the ASSEMBLY section
APPLICATION OF HAND BRAKES
1. Pull the brake towards the handgrips.
2. Do one of the following:
A. STILL - hold the brake handle up:
B. MOVING - Release the brake handle
Fig. 5 (unlocked state)
HANDBRAKE LOCKING
1. Push down on the bottom of the brake handle
in compliance with the drawing until you hear a
click (Fig. 6)
2. For more information, see UNLOCKING THE
HANDBRAKE in this manual.
UNLOCKING THE HANDBRAKE
1. Pull the brake handles upwards until they are
released as shown in fig. 5.
2. Release the brake handle.
3. Make sure the brake cable is placed along the
side-line and the unused part is coiled in front of
the walker.
TECHNICAL PARAMETERS
Overall width: 64 cm
Overall length: 82 cm
Overall height: 92.5 cm
Fig. 6 (locked state)
- 5 -
Seat width: 45 cm
Seat depth: 23.5 cm
Seat height: 55 cm
Rear wheels: 8-inch PVC wheels
Front wheels: 9-inch PVC wheels
Weight: 8.1kg
Package size: 86*26*37 cm
Adjustable handle height: 79-91 cm
Maximum payload: 136 kg
THIS SIGN MEANS A MAXIMUM
WEIGHT OF THE USER!
CLEANING
Rollator can be cleaned with a damp cloth or
sponge with warm soapy water. Domestic anti-
bacterial surface cleaners may be used if required.
Care should be taken not to leave any cleaning
residues on the handgrips or seat (after cleaning)
which may make them slippery when used. Do
not use scouring pads as this may damage surface
coatings.
MAINTENANCE
1. Please ensure that all attachments are always
secured.
2. Check the bolt securing the seat to the side
elements. Tighten if needed.
3. Replace any damaged or damaged parts
immediately.
WHEEL MAINTENANCE
1. Wheels should be cleaned with warm water and
a mild detergent. Pat dry with a dry cloth.
2. Periodically lubricate with 3-in-1 grease if the
wheels begin to squeak.
STORAGE
The product should be stored in a dry and cool
room. Do not expose to direct sunlight.
TARGET PATIENT GROUP
The healthcare professional shall indicate the
use of the device to adults and children on his/
her own responsibility, taking into account the
available variants/sizes/necessary functions/sizes
and indications, bearing in mind the information
provided by the manufacturer.
METHOD OF DISPOSAL OF THE PRODUCT AFTER
REMOVING FROM SERVICE
After the device is withdrawn from use, the medical
device can be disposed of as normal municipal
waste, except for electrical products - proceed
in the manner appropriate for the disposal of
electrical and electronic equipment.