Fieldmann FDU 200801-E Instrucciones De Uso página 19

7. OPERATING INSTRUCTIONS
Turning on/off
The vacuum cleaner turns on using the ZAP/VYP switch (ON/OFF) (Fig. 3).
After turning the vacuum cleaner off
After vacuum cleaning is finished, turn off the appliance using the switch and pull the plug
from mains socket. Remove the hose from the sucking hole; hose removal requires applying
small force. Finally remove accumulated dust from the collecting container (Fig. 4).
8. MAINTENANCE AFTER USE
Unscrew the filter securing bolt and remove the filter.
Then clean or replace the filter.
When disassembling the filter proceed in steps according to Figures 5/A, 5/B.
When assembling the filter proceed in steps according to Figures 5/C.
9. FILTER CLEANING
We recommend to clean filter at least once a month or when it is visibly fouled or vacuum
cleaning force is reduced and motor noise is higher than usual.
Never use vacuum cleaner without installed filter. Operating vacuum cleaner without installed
filter leads to motor damage.
Before filter cleaning always disconnect the vacuum cleaner from power supply.
Filter cannot be cleaned in a dish washer.
Do not use a hairdryer for filter drying.
The best cleaning method is to shake out the filter.
ASH VACUUM CLEANER
Operating instructions | Maintenance after use | Filter cleaning
19 EN
OPERATING INSTRUCTIONS