GE 18 Serie Manual Del Propietário página 14

Preparing to install the refrigerator.
Read these instructions completely and carefully.
Water Supply to the Icemaker (on s ome models)
If the refrigerator has an icemaker, it will have to be
connected to a cold water line.
A water supply kit (containing copper robing,
shutoffvalve, fitungs and instrucuons) is available
at extra cost fi'om your dealer or fi'om Parts and
Accessories, 800-626-2002.
Refrigerator location
Do not install the refrigerator where the
temperature will go below 60°F (16°C)
because it will not run often enough to maintain
proper mmperamres.
Install it on a floor strong enough to support it
fiflly loaded.
Clearances
Allow tt_e %llowing clearances %r ease of
installation, proper air circulation and
plumbing and electrical connections:
Sides .............................. 3/4" (19 ram)
Top ................................ 1" (25 mm)
Back l" (25 mm)
Ifa 19', 22' or 25' model is to be installed next to
awall on the hinge side, allow 1Y._," (38 mm) fbr
door clearance.
Rollers (on somemodels)
Therollers have3 purposes:
F_Rollers a({just so the door closes easily when
opened about halfi_vay.[Raise the front about
3/4" (19 mm) fi'om tt_e floor.]
[_Rollers a({just so the refrigerator is firmly
posiuoned on the floor and does not wobble.
[_Rollers allow you to move the refrigerator away
from tl_e wall ff)r cleaning.
Toadjustthe milers:
Remove the base _'ille
by pulling ()tit at the
bottom.
Turn the two front
roller a(tjusting screws
clockwise to raise the
refrigerator, counter-
clockwise to lower it.
Replace the base grille
by pushing %Iward
until it snaps into place.
14