Makita RP0900 Manual De Instrucciones página 7

Templet guide (Accessory)
The templet guide provides a sleeve through which
the bit passes, allowing use of the tool with templet
patterns.
To install the templet guide, loosen the screws on the
tool base, insert the templet guide and then tighten the
screws.
1
► 1. Screw 2. Base 3. Template guide
Secure the templet to the workpiece. Place the tool on
the templet and move the tool with the templet guide
sliding along the side of the templet.
1
2
3
4
5
► 1. Bit 2. Base 3. Templet 4. Workpiece 5. Distance
(X) 6. Outside diameter of the templet guide
7. Templet guide
2
3
7
6
NOTE:
• The workpiece will be cut a slightly different
size from the templet. Allow for the distance (X)
between the bit and the outside of the templet
guide. The distance (X) can be calculated by
using the following equation:
Distance (X) = (outside diameter of the templet
guide - bit diameter) / 2
Dust nozzle set (Accessory)
1
2
► 1. Dust nozzle 2. Thumb screw
Use the dust nozzle for dust extraction. Install the dust
nozzle on the tool base using the thumb screw so that
protrusion on the dust nozzle fit to the notch in the tool
base.
Then connect a vacuum cleaner to the dust nozzle.
7 ENGLISH