BOMANN HAS 8101 CB Instrucciones De Servicio página 25

• This appliance is not intended to be immersed in water during
cleaning. Please observe the instructions that we have included for
you in the chapter "Cleaning".
Delivery Contents
1 Main body
1 Small round brush
1 Large round brush
1 Volume brush
Assembly / Disassembly of Attachments
WARNING: Risk of burns!
If you want to change an attachment directly after use, let
the appliance cool down first!
Refer to the markings on the main unit and the attachments.
1. Select a desired attachment. Insert the attachment so
that the arrow on the base unit
attachment are aligned precisely above each other.
The attachment must audibly engage.
2. To unlock the attachment, hold the button below the arrow
pressed and pull the attachment upwards.
Commissioning
• Remove all packaging material.
• Unwind the mains cable completely.
• Fit one attachment.
Electrical Connection
• Before inserting the plug into the socket, make sure that
the mains voltage to be used matches that of the device.
You can find this information on the nameplate.
• Connect the appliance to a properly installed earthed
socket.
Use
Switch Positions
The device has a switch with 4 settings. The markings are
located next to the slide switch. You can select the following
functions:
0 =
off
1 = moderate air flow, medium temperature
2 = strong air flow, high temperature
= strong air flow, low temperature
WARNING:
• Before cleaning remove the mains lead from the socked.
HAS8101CB_IM
Using the Round Brushes
The round brushes feature different diameters. Select a brush
according to the desired size of curls.
• Comb your hair and separate it into single strands.
• Twist one hair strand around the brush starting from the
• Then unwind the hair strand again. Blow-dry your hair
Application of the Volume Brush
With the volume brush you can create volume and fullness
in your hair.
and the arrow on the
After Use
• Let your hair cool down completely before continuing to
• Do not comb your hair afterwards if you want to keep the
Switch-off
After use, slide the switch to position "0" and disconnect from
the mains.
Storage
• Leave the device to cool before putting it away!
• To do so, place the appliance onto one side of the housing
Mains Cable
• The mains cable should only be wound up loosely.
• Never tie the cable tightly round the device, as over time
• Check the mains cable regularly for damages.
Cleaning
tips all the way to the hairline. Keep holding the device in
that position for several seconds until the desired degree
of drying and styling has been achieved.
strand by strand.
style it.
curls strong. Just use your fingers for styling.
or hang it up by the suspension eye.
this may result in the cable breaking.
25
09.01.17