Publicidad
Idiomas disponibles
Idiomas disponibles
Illustration
1. CYLINDER 2. PLUG
3. WORKING HANDLE
4. TABLE / BEAM
5. TRUNK GUIDE
6. LOCKING SYSTEM
7. CHASSIS
8. WHEEL
9. ENGINE
10. CARRYING HANDLE
Assembly
STEP 1: HANDLE ASSEMBLY
1. 1. Fix handle #22 at the end of the beam with bolt #23, spring washer #9 and washer #10.
1. 1. Adjust the beam to a horizontal position and fix it with the locking system.
2. Assemble the cylinder and wedge guard to the beam using a hex screw (#16), Pressure washer
, Flat washer and Nut (#11).
2.1 Assemble the two wheels # (39) on the main body using the wheel shaft (# 48), flat washer (#
29) and nut (# 37).
STEP 3: ASSEMBLE THE TRUNK GUIDES
1. Assemble the left and right trunk guides (#2 and #14) using nuts (#8), pressure washer , and
flat washer .
1. 1. Assembly the trunk guard using nuts , flat washer , and bolt
(#7).
STEP 4: HYDRAULIC SLEEVES AND WORKING HANDLE ASSEMBLY
1. 1. Assemble the control handle assembly.
2. Connect the hydraulic hose (#59). Connect the high-pressure hose (#59) that goes between
the distributor and the pump.
77
Publicidad
