Publicidad
SWAY™ WALL CONTROL
NOTE: This model requires the use of the Sway Wall Control (CB-SWAY sold separately).
NOTE: The Sway™ Wall Control runs on low voltage (5VDC) sourced from the electrical enclosure using the CAT5 cable provided with
the lights. It is not directly compatible with 120VAC. Low voltage and dual voltage wiring switch enclosures are available (not included).
Check with local code authority for compliance.
NOTE: Only one Sway™ Wall Control can be used per lighting array.
No more than 6 lights are recommended per array.
1. Connect the provided Cat 5 cable to the Sway™ Wall Control per the diagram found on page 10.
2. Using the screws provided with the Sway™ Wall Control, mount the Sway™ Wall Control to the switch enclosure .
2
© 2022 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376
www.robern.com
Precision Light Control
The Sway Control combines
dimming to control brightness
with color tuning to control
temperature from warm to cool
white light. You can set exactly
what combination is right for
you and come back to that
setting later with a simple tap.
Color Tuning
Tap multiple times to quickly tune color temperature.
Press and hold to fine-tune color temperature.
Increase Brightness
Tap multiple times to quickly increase brightness.
Press and hold to smoothly increase brightness.
Decrease Brightness
Tap multiple times to quickly decrease brightness.
Press and hold to smoothly decrease brightness.
Favorites
Tap to cycle through three preset combinations of color
and brightness or replace with your own favorites.
To Set Your Own Favorites
• Adjust the color temperature and brightness to your preference.
• Press and hold the Favorites button until the indicators flash.
• Tap one of the three flashing buttons to save your favorite.
Each flashing button represents a di erent saved favorite.
• Tap Favorites button to cycle through your new favorites.
Power
Tap to turn lights on or o .
10
Part no. 209-1426 || 09-MAY-2023
Inline™ Tunable Light
Publicidad
